The GLR Report for a Virtual Circuit Displays Only First 11 Chars Of Cross Reference Value in LOCN column (Doc ID 2291336.1)

Last updated on JULY 28, 2017

Applies to:

Oracle Communications MetaSolv Solution - Version 6.2.1 and later
Information in this document applies to any platform.

Symptoms

The entire Cross Reference (X-Ref) value displayed in the LOCN column of theConnection Design > CLR/DLR Design is not displayed in the Location column of the Design Lines Section on the GLR Report. Only the first 11 characters are displayed.

Example:

* Value as viewed in CLR/DLR Design (18 characters)

LOCN
------------------
X-Ref 123456789012345678

* Value as viewed in GLR Report (First 11 characters)

Location
------------------
12345678901

 

EXPECTED BEHAVIOR
-----------------------
The entire Cross Reference (X-Ref) value displayed in the LOCN column of the Connection Design > CLR/DLR Design should be displayed in the Location column of the Design Lines Section on the GLR Report.

 

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

1. Inventory Management

2. Connection Design

3. Query for a Virtual Connection

4. Open the Virtual Connection's Connection Design

5. Click CLR/DLR Design

6. Click Add Cross-Reference

7. Select a Connection Reference and click Add to Design then Close

* Note the X-Ref value in the LOCN column and ensure it is greater than 11 characters

8. Save the Connection Design (Current or New Issue)

9. Select Outputs > GLR from the CLR/DLR Design

10. Scroll down to the Design Lines Section of the Graphical Layout Record

* Note that only the first 11 characters of the X-Ref value are displayed

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms