My Oracle Support Banner

MCAD Connector Shows Incorrect Status for Component That Were Not Fully Loaded to Agile (Doc ID 2308794.1)

Last updated on SEPTEMBER 19, 2017

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.4.1 and later
Information in this document applies to any platform.


Actual Behavior

Files which could not be saved to Agile due to whatever problem are not displayed as PLM-known and in-sync with PLM upon opening the Save Preview subsequently or the Workspace Manager.

Expected Behavior

Files which could not be saved to Agile should be displayed as PLM-unknown or "locally modified" but PLM-known.


The issue can be reproduced at will with the following steps:
1. Saving/checking-in assemblies from Solidworks to Agile using MCAD connector
2. Run Save Preview


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.