My Oracle Support Banner

Workspace Displays Wrong Revision When Using Solution Pack To Increment Revision (Doc ID 2311670.1)

Last updated on FEBRUARY 28, 2019

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.3.0 and later
Information in this document applies to any platform.


 MCAD connector requires the Solution Pack to increment revisions based on a specified sequence. With Solution Pack updating the rev triggered by a change status event, the Workspace does not display the new rev created.

Steps to Reproduce:

The part is added to a change with pending rev B. the Assiciated design is checked in -> ver: 8 B.1

The associated design is checked out and in while the change is in Pending status -> ver: 9 B.2

The change is submitted, Solution Pack sets the associated Design rev to (B).1 -> ver: 9 (B).1

WebClient shows (B).1:


Workspace after refresh shows B.2:


Expected Behavior:

The expected revision in the MCAD workspace should match the one in WebClient, which is the value set by the Solution Pack.


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.