Edited Value in Switching Step Being Used When Pasted as a Goback Step
(Doc ID 2315586.1)
Last updated on JULY 07, 2022
Applies to:
Oracle Utilities Network Management System - Version 1.12.0.3 and laterOracle Network Management for Utilities - DMS - Version 1.12.0.3 and later
Information in this document applies to any platform.
Symptoms
On : 1.12.0.3 version, Web Switching
After installing an NMS patch, the behavior of goback steps changed slightly. Certain edited fields (such as the operation description) were not cleared out in the go-back step.
For example if the original step is 'Open Device' and has been edited to 'Open Device w/comment', the goback step would, INCORRECTLY, have 'Open Device w/comment' rather than 'Close Device'.
Go-back steps should use their default description, not the description of the original edited step.
The issue can be reproduced at will with the following steps:
1. Create a new planned switch sheet
2. Record a single "Open Device" step
3. Stop recording
4. Edit the Description and change it to "Open Device Test"
5. Copy the step as a go-back
6. Paste the step
7. The new go-back step will have the same description as the original step.
Changes
An NMS patch was recently installed.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Changes |
| Cause |
| Solution |
| References |