My Oracle Support Banner

Close Cross Phase Jumper Between Hot Phases Displays an Incorrect Message (Doc ID 2333047.1)

Last updated on FEBRUARY 28, 2019

Applies to:

Oracle Utilities Network Management System - Version to [Release 2.3]
Oracle Network Management for Utilities - DMS - Version to [Release 2.3]
Information in this document applies to any platform.


Close cross phase jumper between hot phases displays an incorrect message.

If you place a point to point cross phase jumper between two hot conductors, e.g. in OPAL around fuses F1555 (on feeder 2411) and F1556 (also on feeder 2411) and then attempt to close the jumper, you see a message that you are about to create a parallel on Feeders 2411 and 2411_Bus (which feeds 2411).

The message indicating a parallel would be created is incorrect. Expect a message "Cannot connect two different hot phases".

1. Place a point to point cross phase jumper between two hot conductors
2. Attempt to close it, note the error.




To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.