The Activity Code Filter Wrongly Applies To All Projects Instead Of The Specified Project In Gateway Business Flow Or Sync Job

(Doc ID 2342332.1)

Last updated on JANUARY 23, 2018

Applies to:

Primavera Gateway - Version 15.1.0.0 to 15.1.6.0 [Release 15.1]
Information in this document applies to any platform.

Symptoms

ACTUAL BEHAVIOR
---------------
The Activity Code filter applies to all projects instead of the specified project in Gateway business flow or sync job.

EXPECTED BEHAVIOR
-----------------------
The Activity Code filter should apply to the specified project ONLY in Gateway business flow or sync job.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Assign the activity code to activities from different projects.
2. Configure the Activity Code filter, and the specified project to be synchronized.
3. Enable the Compare Flag.
4. When running the sync, it is found that all activities having the activity code assigned of all projects are retrieved from either source and destination for data comparison, instead of the activities of the specified project.

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, the data synchronized are not correct.

Note: Sometimes if there is a large set of activities under many different projects, it might cause a Timeout issue for loading a large volume of data.

 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms