My Oracle Support Banner

VEE-Rule(D2-IntervalAdjustmentFromScalar) Abnormal Behavior (Doc ID 2349747.1)

Last updated on NOVEMBER 07, 2018

Applies to:

Oracle Utilities Meter Data Management - Version 2.2.0.1.0 and later
Information in this document applies to any platform.

Symptoms

In MDM miscalculations have been found in the Interval Adjustment from Scalar VEE Rule (D2-IntervalAdjustmentFrmScalar). The adjustment done from scalar measuring component to interval measuring component is found to be not equal.

The issue can be reproduced at will with the following steps:
Following are the steps to recreate the issue
1- Created a VEE group using VEE rule D2-IntervalAdjustmentFrmScalar.
2- Referenced it on Interval measuring component.
3- Created a smart meter device and configured it with a scalar measuring component and an interval measuring component.
4- Referenced the scalar measuring component on interval measuring component.
5- Referenced the VEE Group for Manual IMD.
6- Entered a non zero reading on scalar MC. For example, January 1, 2018 00:00:00 thru January 2, 2018 00:00:00 (24 hours) with quantity = 100.
7- Entered a zero reading with missing condition code on interval MC.
8- When finalized the IMD the summed up value for all the intervals was not equal to 100. Interval quantities are "4".


Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.