My Oracle Support Banner

MSCCPP - Copy Plan Is Completing In Warning (Doc ID 2357814.1)

Last updated on FEBRUARY 21, 2019

Applies to:

Oracle Advanced Supply Chain Planning - Version 12.1.3.8 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3.8

Plan ST-GLOBAL1 was copied from ST-GLOBAL and although there was a warning, copied data looked correct.

Copy plan log file shows
MSCCPP5 module: Copy Plan

mbp flat file dir /apps/apps_st/conc/out/data3062/
Entering mrcpfl_copy_files()
mrldcf : unable open data file # 300 /apps/apps_st/conc/out/data3062/MSLD_FULL_PEGGING.dataffopen :: Value too large for defined data type
WARNING: The copy plan operation completed successfully. However, some
auxiliary data files could not be copied. Therefore, you will not be able to run on-line planner.
You can re-launch the plan from the Navigator.

Profile MSC_ENBL_COPY_LARGE_PLAN / MSC: Enable Copy Large Plan in Linux 32 bit - Yes - same setting for several years

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Run copy plan for our large plan
2. Cannot run Simulation plan with this failure



Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.