My Oracle Support Banner

Jumper Placement Failure Error Message Has No Content (Doc ID 2370510.1)

Last updated on MARCH 22, 2018

Applies to:

Oracle Utilities Network Management System - Version 1.12.0.3 to 2.3.0.1.0 [Release 1.12 to 2.3]
Oracle Network Management for Utilities - DMS - Version 1.12.0.3 to 2.3.0.1.0 [Release 1.12 to 2.3]
Information in this document applies to any platform.

Symptoms

When placing a P-P Jumper OR Emergency Cable on a two conductors with a different phase the system brings up the "Jumper placement Failed" pop up window but it has no content.

The error dialog should say "Unable to perform Point-to-point jumper model edit. Conductors must have a common phase to insert a jumper between them."

The issue can be reproduced at will with the following steps:
1. On an OPAL system, place a normal point-to-point jumper between
OH1P-2276542-479498-2276353-479520
and
OH1P-2276740-479033-2276314-479053

2. It will fail because they are on different phases, but the error dialog will be blank.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.