Rate Schedule’s Rate Component Type Apply To For The Below Scenario As It Is Not Working (Doc ID 2406459.1)

Last updated on MARCH 22, 2019

Applies to:

Symptoms

On : 2.6.0.1.0 version, ENV - Environment

ACTUAL BEHAVIOR
---------------
Rate Schedule’s Rate Component Type Apply is not working

When Rate Schedules Rate Component Type is Apply to with Value Type as Unit Rate then unit rate is not being apply on rate amount of other rate component.

EXPECTED BEHAVIOR
-----------------------
When Rate Schedules Rate Component Type is Apply to with Value Type as Unit Rate then unit rate should apply on rate amount of other rate component.

Example -

RC 10- Value Type is Unit Rate having Flat Charge of 1000.
RC 20 Value Type Unit Rate having Value 1.
Expected output of RC 20 (1*1000) = 1000.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1) Create Rate Schedule with Apply to Rate Component Type as below.
RC 10- Value Type is Unit Rate having Flat Charge of 1000.
RC 20- Value Type is Unit Rate having Value 1.
2) Create Billable charge.
3) Create Bill.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.