NextFocusZoomToPartitionCommand Does Not Work After Initial Search in Viewer

(Doc ID 2414540.1)

Last updated on JUNE 25, 2018

Applies to:

Oracle Utilities Network Management System - Version 2.3.0.1.0 to 2.3.0.2.0 [Release 2.3]
Oracle Network Management for Utilities - DMS - Version 2.3.0.1.0 to 2.3.0.2.0 [Release 2.3]
Information in this document applies to any platform.

Symptoms

If the DLG_VIEWER_SEARCH is configured so that a given search uses SearchFocusCommand and then NextFocusZoomToPartitionCommand, the NextFocusZoomToPartitionCommand does not always get triggered.
 

Expect the whole feeder to be shown each time the search is performed

The issue can be reproduced at will with the following steps:
Launch web workspace
Grab authority
Start a viewer.
Search for a large feeder (providing the full name, so no selection list is presented)
The viewer will show the whole feeder

Shift+U
Search for the feeder again (providing the full name, so no selection list is presented)
The viewer will show a conductor

Shift+U
Search for the feeder by providing a portion of the name and selecting the name from the list.
The viewer will show the whole feeder

Changes

 The Viewer's Search dialog configuration ($NMS_CONFIG/jconfig/ops/viewer/xml/DLG_VIEWER_SEARCH.xml) calls NextFocusZoomToPartitionCommand immediately after the SearchFocusCommand.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms