IPSA Auditing Does Not Recognize Route Targets With IPv4 Addresses As The 1st Part On Cisco IOS XR (Doc ID 2479259.1)

Last updated on MARCH 11, 2019

Applies to:

Symptoms

Create a mesh IPv4 only VPN with one route target for both import and export, that uses the IPv4 address as the first token of the route target.  Push to a Cisco IOS XR device then run an audit.

The audit will show the route target configuration but those commands will be missing the actual route target itself.

Example:
vrf My_VRF
  address-family ipv4 unicast
  import route-target
  1.2.3.4:1234   

export route-target
  1.2.3.4:1234

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.