Scalar Profile Estimation Rule Always Estimates Zero When Profile Measuring Component is Standalone (Doc ID 2515168.1)

Last updated on SEPTEMBER 28, 2022

Applies to:

Symptoms

On : 2.2.0.1.0 version, Validation, Edit, Est Rule

ACTUAL BEHAVIOR
---------------
Scalar Profile Estimation rule always estimates 0 value irrespective of positive reads prevent


When uploading a missing scalar IMD where Scalar Profile Estimation is the only rule in the VEE group, the read gets estimated with 0 value despite positive reads present on profile MC referred in VEE rule through a factor.


EXPECTED BEHAVIOR
-----------------------
It is expected that Scalar Profile Estimation would create estimated values with correct conditions in place.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Put only Scalar Profile Estimation VEE rule in place for this test
2. Ensure factor referenced and profile are in place for the dates in question
3. Create imd with 0 value and missing condition such that estimation will be initiated.
4. This always results in a zero value estimation

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, users cannot estimate using the Scalar Profile Estimation rule.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.