My Oracle Support Banner

MDM Accepting Negative Reads – IMD With Negative Scalar End Read Is Getting Finalized (Doc ID 2529204.1)

Last updated on OCTOBER 06, 2022

Applies to:

Oracle Utilities Meter Data Management - Version 2.2.0.1.0 to 2.3.0.0.0 [Release 2.2 to 2.3]
Information in this document applies to any platform.

Symptoms


When an IMD with negative scalar end read is uploaded, its getting finalized instead of MDM raising any exception/error

EXPECTED BEHAVIOR
-----------------------
IMD status should be exception instead of getting finalized.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create MC type for D1-Register BO.
2.Create the device configuration type on the above MC type.
3.Create a device and device configuration.
4.Add Register Scalar MC on the above device configuration.
5.Create a Service point and install event.
6.Add negative scalar readings on the MC through XAI submission.
7.The negative reads are accepted without throwing any error/exception.

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.