My Oracle Support Banner

Entire Work Order Quantity Is Getting Pegged To Excess (Doc ID 2536112.1)

Last updated on OCTOBER 07, 2019

Applies to:

Oracle Advanced Supply Chain Planning - Version 12.1.3 to 12.2.8 [Release 12.1 to 12.2]
Information in this document applies to any platform.

Symptoms

On : 12.2.4 version, Memory Based Planner

When you use constrained without detailed scheduling and noticing that for plans some of the work orders are being entirely pegged to excess and there is no cancellation recommendation.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Log into ASCP Responsibility
2. Run the Plan
3.Review the plan output results


Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.