My Oracle Support Banner

ODB++ File is Displayed As Non-Orthologonal Angle In AutoVue 21.0.2 (Doc ID 2606523.1)

Last updated on OCTOBER 31, 2019

Applies to:

Oracle AutoVue Electro-Mechanical Professional - Version 21.0.2 and later
Information in this document applies to any platform.

Symptoms

ACTUAL BEHAVIOR
If components are placed on a PCB at an angle that is not 90 degrees (e.g. 35 degrees), the
display of the pads in ODB++ files in AutoVue is displayed in correctly.

FACT
Affected File :ODB++ Version 7

STEPS
The issue can be reproduced at will with the following steps:
1. Open ODB++ version 7 files in AutoVue 21.0.2

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.