My Oracle Support Banner

OUTA-"F1-SendResultsMail" Component Doesn't Send An Email In A New Test Flow. (Doc ID 2646861.1)

Last updated on MARCH 12, 2020

Applies to:

Oracle Utilities Testing Accelerator - Version 6.0.0.1.0 and later
Information in this document applies to any platform.

Symptoms

On : OUTA 6.0.0.0.0 version, OUAF

ACTUAL BEHAVIOR
---------------
OUTA-"F1-SendResultsMail" component doesn't send an email in a new test flow.

If we create a new test flow and drag drop the "F1-SendResultsMail" component, no status email will be sent when the flow is executed.

WorkAround: open the test data for the F1-SendResultsMail component and click on SaveAndClose button, generate the flow script again and run it.



EXPECTED BEHAVIOR
-----------------------
Status email should be sent to the user without opening and save and close the data bank since the fields in the data bank doesn't require any input. As this is driven by configuration.properties.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create a test flow, then drag and drop the "F1-SendResultsMail" component into the flow. No input is needed for SendResultsMail component as it is driven by config.
2. Setup the configuration.properties to send email to you. I had setup like below
  #Email Details
gStrSMTP_HOST_NAME= mail.ouc.com
gStrSMTP_PORT= 25
gStrTO_EMAIL_RECIPIENTS= abc@ouc.com
3. Execute the test flow, the test results email should be sent to the user but it is not.


Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.