My Oracle Support Banner

DMStudio Tables Not Retaining Position, Dimensions Or Column Widths (Doc ID 2692000.1)

Last updated on JULY 20, 2020

Applies to:

Oracle Documaker - Version 12.6 and later
Information in this document applies to any platform.

Symptoms

On : 12.6.2 version, Documaker Studio

ACTUAL BEHAVIOR
---------------

Created a table in DMStudio. The horizontal, width and column widths entered are not being retained. Also, when entering and lock the column widths the final column width being calculated is not the total width minus the sum of the other column widths.


EXPECTED BEHAVIOR
-----------------------
Expecting table properties entered to be used.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
Enter 7 columns, no link to XDD, and enter the following values: 2.1, 2.4, 1.3, 2.7, 1.7, 2.2 in Col 1-6, totalling 12.4. Based on a 13.5cm width, it should be calculating Col 7 at 1.1cm




Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.