Fields Not Sync Using D1-ODMSPSyncRequest Initial Sync
(Doc ID 2692361.1)
Last updated on SEPTEMBER 24, 2022
Applies to:
Oracle Utilities Customer to Meter Base - Version 2.7.0.3.0 to 2.7.0.3.0 [Release 2.7]Information in this document applies to any platform.
Symptoms
On : 2.7.0.3.0 version, Installation and Patching
ACTUAL BEHAVIOR
---------------
Fields not sync using D1-ODMSPSyncRequest Initial Sync
EXPECTED BEHAVIOR
-----------------------
Fields should be sync using D1-ODMSPSyncRequest Initial Sync
STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Take note of the discrepancy between the business object xpath elements. Since these are mapped to BO_DATA_AREA they need to be the same.
D1-ServicePointODMBORead X1D-ServicePoint
siteLocation deviceLocation
siteLocationDetail deviceLocationDetails
spInstructionDetail spInstructionDetails
What is happening now is that the fields in the MDM SP are not being extracted even if they are populated:
• deviceLocation
• deviceLocationDetails
• spInstructionDetails
2. Testing
Service Point
SP ID: <input ID>
Run Batch F1-SYNIL
Batch run completed successfully.
3. Outbound Sync Request
Notice that the extracted fields are blank:
• siteLocation
• siteLocationDetail
• spInstructionDetail
4. Inbound Sync Request
Notice that the fields are blank:
• siteLocation
• siteLocationDetail
• spInstructionDetail
5. Run Batch F1-SYSRQ
Batch run completed successfully.
6. Results
Sync Request transitioned to Data Transformed / Basic Schema Validation
Site Location (Device Location), Site Location (Device Location) Detail and SP Instruction Detail are blank.
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
| Symptoms |
| Cause |
| Solution |
| References |