Installation Constant or Meter Multiplier Being Applied in Error when Manual IMD is Created (Doc ID 2756241.1)

Last updated on MARCH 18, 2021

Applies to:

Symptoms

Measurement issue with multiplier being applied in error when Manual IMD is created.

When creating a new manual IMD in MDM for a date/time using ‘Copy Existing Measurements’, MDM is reapplying the installation constant or meter multiplier to the measurements that are already existing on the D1_MSMRT table. This results in inaccurate measurements using this function.

For example, if there is an IMD that comes in with quantity of 20 and then a multiplier of 5 is applied, the resulting measurement is saved with a value of 100.

Then if we use that same measurement as a basis for "Copy Existing Measurements" then the multiplier of 5 is applied again and the result is a measurement with a value of 500. It is expected that the multiplier would not be applied in this scenario.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.