My Oracle Support Banner

Path Analysis Not Returning Paths With STM (SDH) Connectivity (Doc ID 2757404.1)

Last updated on MARCH 09, 2021

Applies to:

Oracle Communications Unified Inventory Management - Version 7.4.1.0.0 and later
Information in this document applies to any platform.

Symptoms

On : 7.4.1.0.0 version, Other Issues

ACTUAL BEHAVIOR
---------------
Path Analysis not returning paths with STM (SDH) connectivity


EXPECTED BEHAVIOR
-----------------------
Expected Result : It should return path ld1 - ld2 - ld3.

Actual Result : No path found.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1) Create 3 Logical Devices with STM 1 device interface and associate them with network entity code like Loc1.LD1 , Loc1.LD2, Loc1.LD3 .
2) Create 2 connectivities LD1 - LD2 and LD2 - LD3 with rate code STM1. Connectivities are in In Progress state.
3) Create a network. Add 3 nodes and associate these 3 nodes with 3 LDs . Create 2 edges between LD1 - LD2 and LD2 - LD3 and associate these edges with 2 connectivities.
4) Go path analysis link and select source and target as Ld1 and Ld3.


Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.