My Oracle Support Banner

Study Mode PF Results Showing Characters In Device Details (Doc ID 2769489.1)

Last updated on APRIL 16, 2021

Applies to:

Oracle Utilities Network Management System - Version 2.4.0.1.0 to 2.5.0.1.0 [Release 2.4 to 2.5]
Oracle Network Management for Utilities - DMS - Version 2.4.0.1.0 to 2.5.0.1.0 [Release 2.4 to 2.5]
Information in this document applies to any platform.

Symptoms

On : 2.4.0.1.0 version, Viewer, Device Details.

Study mode PowerFlow Results showing "NaN" characters in Device details

Under certain circumstances, the Device Details panel, in the Power Flow Results tab shows "NaN" values instead of "0" for a substation with a "model Error" state.

Further analysis shown that the power flow results are "nan" due to a load on the feeder. All the attributes and profiles on that load point seem to be correct.

All strings should be readable

The issue can be reproduced at will with the following steps:

1. Find a circuit with 2 phase delta loads, in an island that is in model error status
2. Switch to study mode, and initialize to show real-time load conditions
3. Navigate to the 2-phase delta load and bring up power flow results.

Without fix: invalid and not-a-number symbols can be shown
With fix: zeros should be shown.



Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
 Fix Description
 Migration
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.