Save As Post Event Fails to Update Attribue of Manuracturer Part Being Created (Doc ID 2804489.1)

Last updated on JANUARY 24, 2024

Applies to:

Symptoms

Actual Behavior

Process extension Save As post event cannot update attribute of the object being created by Save As.
Enabled Manufacturer Part PAGE_TWO.TEXT02 attribute, and developed save as event process extension java code to update this field with the Object ID of the newly created manufacturer part on Save As event.
However, after performing Save As on Manufacturer Part, see the value is being updated to the attribute of the object which Save As was initiated, not to the manufacturer created newly created by Save As.

Expected Behavior

Process extension save as post event can update the attribute of the newly created object



Steps

The issue can be reproduced at will with the following steps:

[Preparation]

1. Build PX jar file from below source code:
    
2. Check Page Two.Text02 of MP00012. See below is added:
   6022228
3. Check Page Two.Text02 of MP00013. See it shows blank. This is same as what it was set to MP00012
   Expected Result. Page Two.Text02 of MP00013 will have the value Object ID of MP00013

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.