My Oracle Support Banner

After Starting Creo2.0 With MCAD Connector 3.6.3, Agile Workspaces Cannot Be Used with Error with Creo Toolkit: Unable to load application 'xACP_36', it is not a DLL (Doc ID 2892914.1)

Last updated on JANUARY 24, 2024

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.6 and later
Information in this document applies to any platform.

Symptoms

After starting Creo 2.0 with MCAD 3.6.3, Agile workspace cannot be used with below error in Creo:


Error

Creo Toolkit registry file C:\Agile\work\protk.dat: Unable to load application 'xACP_36', it is not a DLL




Steps

The issue can be reproduced at will with the following steps:

  1. Upgrade MCAD connector to 3.6.3
  2. Start Creo 2.0 with MCAD connector 3.6.3
  3. Gets the error in Creo

Changes

Upgraded MCAD connector to 3.6.3

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.