Design number Is Automatically Changed to Part Number and Not Kept As Filename When the Drawing Is Associated with Part through MCAD Connector Agile Save Preview window (Doc ID 2925795.1)

Last updated on JANUARY 24, 2024

Applies to:

Symptoms

Actual Behavior

Design number is automatically changed to the Part Number when the CAD drawing file is associated with part through MCAD Connector Agile Save Preview window

Expected Behavior

Keep the CAD drawing file name as the Design Number after the local drawing file is associated with the part through MCAD Connector Agile Save Preview window, so that Design Number will be consistent with the local CAD drawing file name.

Steps

The issue can be reproduced at will with the following steps:

1. Open a local part drawing by from Creo integrated with MCAD connector.
2. Go to Tool > Agile > Save Preview.
3. Agile Save Preview window shows up.
4. Search and assign the part that already exists in Agile system.
5. Add values to design attributes.
6. Select Save.
7. At this moment the design number is automatically changed to the part number.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.