My Oracle Support Banner

After Starting MCAD Connector for PTC Creo Parametric, the Value of Save_display Gets Updated to 'no' in config.pro File (Doc ID 2947373.1)

Last updated on JANUARY 24, 2024

Applies to:

Oracle Agile PLM MCAD Connector - Version 3.6 and later
Information in this document applies to any platform.

Symptoms

After starting MCAD Connector for PTC Creo Parametric, the value of save_display gets updated to 'no' in config.pro file, and unable to keep the default value of save_display set to 'yes'.


The issue can be reproduced at will with the following steps:

  1. Edit config.pro file stored under \AgileEC\work, and change the value of save_display to 'yes' and save.
  2. Run \AgileEC\acp\com\acp_start.bat to start MCAD connector for PTC Creo Parametric.
  3. Open config.pro under \AgileEC\work, see the value of save_display is updated to 'no' again.


Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.