Error "Status(es) <status1>,<status2>,<status3>, must be selected on the Statuses tab of <BPname> business process" When Setting a Business Process to Complete (Doc ID 2987722.1)

Last updated on NOVEMBER 20, 2023

Applies to:

Symptoms

When attempting to set a Business Process (BP) to status "Complete" in uDesigner, the following Error Check Warning is displayed within Unifier. This is a contract type BP that is being renamed to "BP1". However in the Error Check alert a different BP called BP2 is being referenced even though there is no auto-create or validation in BP1 that references BP2. It may be thought that the error message was incorrectly referring to the other BP.

EXPECTED BEHAVIOR
-------------------------------
The following message should not be displayed in the Error Check window and "BP1" should go to Complete status.
"Status(es) <status1>,<status2>,<status3>, must be selected on the Statuses tab of <BP2> business process."

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

1. Log into the Unifier environment.
2. Navigate to Company Workspace > Admin Mode > uDesigner > Business Processes > BP1 > click "Status", set to "Complete" > An "Error Check" window opens with the Error/Warning message noted above and points to a different BP that doesn't seem related.

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.