OFSAA FTP Issues With Delete, Add and Update of FTP Method Definitions for Multiple Filters in Conditional Assumption Screen (Doc ID 3021361.1)

Last updated on MAY 28, 2024

Applies to:

Symptoms

On FTP 8.1.2 unable to add Filter in Rule Conditional Assumption screen when there are multiple filters in the conditional assumption after deleting existing Filters in the screen.
The same filter works if added in a brand new TP rule or if adding to existing Conditional Assumption definition.  The drop downs for Data Source and Method are blank after selecting the new filter.



In addition, if there are multiple filters in the conditional assumption, after selecting the TP method definition for one filter, and then selecting the a second filter, when navigating again back through the definitions, incorrect selected Assumption values like Term are displayed.

The issue can be reproduced at will with the following steps:

DELETE FILTERS ISSUE
1. Open existing TP rule where several filters are defined in Conditional Assumption screen.
2. Delete all existing Filters and attempt to add a new Filter from selection
3. The filter adds but the screen does not refresh and shows blank drop down for Data Source

INCORRECT TP METHOD ASSUMPTION DISPLAY ISSUE
1. Open existing TP rule where several filters are defined in Conditional Assumption screen.
2. Select a Filter with Straight Term method and check displayed Term



3. Select a different filter with Straight Term method and different Term in Assumptions



4. Select original Filter again and see incorrect Term is now displayed

Changes

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.