Cannot Configure 10000 With MQC (Doc ID 442028.1)

Last updated on NOVEMBER 16, 2016

Applies to:

Oracle Communications IP Service Activator - Version: 3.2
Sun Solaris SPARC (32-bit)

Symptoms

The problem was that the caps file and the UI say single rate policing etc issupported on the interface, but when the 
UI tries to apply the config, the following error appears:

NotSupported: Mqc not supported inbound on Serial1/0/1.1/1/1/1:0

It does apply it correctly to the 7513s we are using, it is only a problem for the ESR (which we are using in the live network). Additionally, I have copied the config (policy-map, class-maps and service-policy statement) from one of 7513s which it has been been applied to and pasted it onto the ESR and the ESR takes the config OK.I have uploaded the caps files I am using (same ones as before), along with some screen shots of the policy, showing the error message, the interface caps and the ESR properties.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms