My Oracle Support Banner

How To Install and Configure Print Commander to Run the DCD to FAP Conversion (Doc ID 787600.1)

Last updated on DECEMBER 03, 2019

Applies to:

Skywire PrintCommander - Version 5.0.0 to 6.0.13 [Release 5.0 to 6.0]
Skywire Documerge - Version 5.0.0 and later
Oracle Documaker - Version 10.2 to 12.0.0
Information in this document applies to any platform.

Purpose

This article describes how to install and configure Print Commander to run the DCD to FAP conversion utility.

Scope

These instructions are valid for products known as Common Objects, Control Panel, Print Commander, and Documaker Full System.

Details

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Purpose
Scope
Details
 Overview:
 Installation:
 Configuring Printcommander:
 Setup:
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.