My Oracle Support Banner

SONET Network,only one path is shown in CLR Preview report when Rider is created with Full Ring option. (Doc ID 987506.1)

Last updated on APRIL 27, 2021

Applies to:

Oracle Communications Objectel - Version 2.10.0 and later
Information in this document applies to any platform.

Goal

In three or more node SONET Networks, when a rider is created with Full channel Option; In CLR Report only one of the two paths(Working Path) details has been shown. Though in the table below : the channel Assignment table contains full two path details(Working path and Protection path),but Channel assignment diagram in CLR Report does not show the protection path details.

Replication Steps:
1.Created 3 node Sonet networks
1.a Created a base facility between A1-A3 and A3-A2.
1.b Created a base facility between A2-A1
1.c While creating a rider facility between A1-A2, I got two paths,
1.c.1 A1-A2
1.c.2 A1-A3-A2
In case of following half ring and full ring scenarios:
2.Half Ring Scenarios:
2.A)Select half ring between A1-A3-A2 ,In CLR report ,I could able to see the connection from
A1-A3-A2 .
2.B)Select half ring between A1-A2, i could able to see the connection from A1-A2.

3)Full Ring Scenario:
But when selecting full ring option between A1-A3-A2 and A1-A2, In CLR Report, i could able to see only connection of A1-A2 only but not A1-A3-A2 connection.

In the CLR Report where Full ring is reserved, we could able to see only A1-A2 path but not the other path ie A1-A3-A2.




Solution

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document
Goal
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.