Operation Sequence Defaults to '1' and Cannot Be Changed on Item Structure

(Doc ID 2281211.1)

Last updated on OCTOBER 17, 2017

Applies to:

Oracle Fusion Product Development Cloud Service - Version 11.1.11.1.0 and later
Oracle Fusion Product Hub Cloud Service - Version 11.1.11.1.0 and later
Information in this document applies to any platform.

Symptoms

ACTUAL BEHAVIOR
---------------
After Importing an Item Structure where Components had Operation Sequence of 20 or 60 assigned -> all Components show in Fusion with an OP Sequence of 1

EXPECTED BEHAVIOR
-----------------------
Operation Sequence numbers would match what was imported.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Prepare Item Structure Import Template with Operation Sequence values
2. Import Item Structures
3. Navigate to Product Information Management
4. Search for the Item -> Select Structures tab -> Open Structure
5. Observe all OP Sequence numbers are 1

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms