My Oracle Support Banner

GL Approval Rule set Condition with the Job Code is not working (Doc ID 2712085.1)

Last updated on SEPTEMBER 28, 2020

Applies to:

Oracle Fusion General Ledger Cloud Service - Version 11.13.20.04.0 and later
Information in this document applies to any platform.

Symptoms

ACTUAL BEHAVIOR
---------------

 BPM approval notification is not sent for the approval as per the rule set defined based on Job code.

EXPECTED BEHAVIOR
-----------------------
Journal should be sent for approval based on the job code condition in the ruleset.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create a job with the name like AP USER and with job code AP_USER
2. Assign the job to Test.User
3. Configure BPM task Fin GlJournalApproval
4. Create a rule set like "Supervisory Journal approval Rule set with the below rule condition
IF Journal Batch Creator Job Code is 'AP_USER'
Then List Builder > Resource,Responsetype> Required,User > Approver1
5. create a journal by the Test.User who is assigned with the job AP_USER  and sent it for approval.



Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.