My Oracle Support Banner

ODA (Oracle Database Appliance): How To Configure xbond,bond1,bond2 on ODA V1 post deploy (Doc ID 1422563.1)

Last updated on FEBRUARY 06, 2020

Applies to:

Oracle Database Appliance Software - Version to [Release 2.1]
Linux OS - Version Oracle Linux 5.0 to Oracle Linux 5.0 [Release OL5]
Oracle Cloud Infrastructure - Version N/A and later
Information in this document applies to any platform.


You have executed the ODA deploy without setting up the xbond0, bond1, bond2 network interface. Now for several reasons (backup, middle-ware client connections, application client connections, ...) you need to configure them.
Using the "firstnet" configuration, like

It will restart the network ("service network restart")
on the ODA which will cause a brief interruption to the current connected users to the system (if the IP which was being used for connection is not being changed), and moreover "oakcli configure firstnet" runs on local node only

Following this note, fully applicable on ODA V1, you can configure your xbond0, bond1, bond2 without any interruption


To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!

In this Document
 How To Configure xbond,bond1,bond2 post deploy manual mode
 How To Configure xbond,bond1,bond2 post deploy using ODA Configuration Manager
 1. ODA Manager
 2. Custom type configuration
 3. Other Network screen
 4. save the new deploy
 5. check your settings
 6. Run deploy steps 3,1,24

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.