My Oracle Support Banner

Oracle Big Data Appliance Base Image Version 4.5.0 for New Installations or Reprovisioning Existing Installations on Oracle Linux 5 (Doc ID 2174219.1)

Last updated on JANUARY 14, 2020

Applies to:

Big Data Appliance Integrated Software - Version 4.5.0 and later
Linux x86-64

Purpose

This document provides details for re-imaging the Oracle Big Data Appliance Base Image to version 4.5.0 on OL5. The document describes the steps on how to re-image a single server or an entire Oracle Big Data Appliance or a cluster of BDA servers.

The document describes the steps on how to re-image a single server or an entire Oracle Big Data Appliance or a cluster of BDA servers. It's recommended to re-image to the latest BDA 4.5.0 on a machine that came from factory with a lower release say 4.4.0 or lower, as the 4.5.0 image will install OL6 with UEK v2. Upgrades will continue to run OL5 and UEK v1. This is because Oracle Linux does not offer an upgrade path from OL5 to OL6.

It is recommended for all new customers to install Oracle Linux 6. Follow steps for OL6 from the following document:Oracle Big Data Appliance Base Image Version 4.5.0 for New Installations on OL6 (Doc ID 2173434.1).

In most cases, there would be no reason to reimage to the v4.5.0 base image for OL5. Only in a specific case that the customer has to have OL5 instead of OL6 would these steps be followed. If there is a need to reimage an X5-2 or X6-2 BDA server with Oracle Linux 5 (this is an extension of an existing cluster, not a new cluster) then use the new BDA Base Image v4.5.0 for OL5. If an OL5 cluster is being extended onto X5 servers or X6-2 servers then the cluster version must be BDA v4.5.0 or higher.

  

Note: This BDA Base Image can only be used for reimaging. It does not contain a rescue image (and should not be used on a node that is down unless the goal is to reimage). In other words this base image can not be used to boot a node, only to reimage a node.

  

Scope

This information is intended to be used by field support or a system administrator when re-imaging the Oracle Big Data Appliance X3-2, Oracle Big Data Appliance X4-2, Oracle Big Data Appliance X5-2, or Oracle Big Data Appliance X6-2 to version 4.5.0.

Details

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Purpose
Scope
Details
 Known Issues
 Instructions for Re-Imaging a Single BDA Server
 Mandatory Prerequisites
 Detailed Steps
 Instructions for Re-Imaging an Entire Big Data Appliance
 Mandatory Prerequisites
 Detailed Steps
 Instructions for Re-Imaging a Cluster of BDA servers
 Mandatory Prerequisites
 Detailed Steps
References

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.