Adding Node Back into a BDA Cluster with "mammoth -e" Fails with "ERROR: Cannot determine installed Base Image version"
(Doc ID 2444603.1)
Last updated on JULY 20, 2024
Applies to:
Big Data Appliance Integrated Software - Version 4.10.0 and laterLinux x86-64
Symptoms
When a non-critical node is being added back into a BDA cluster after removing it via the steps in, "How to Remove Non-Critical Nodes from a BDA Cluster (Doc ID 2244458.1)", by following the section of the note entitled "How to Add a Non-Critical Node Back into the Cluster" the re-add with "./mammoth -e" fails with:
ERROR: Cannot determine installed Base Image version
ERROR: Cannot continue with install #Step 1#
ERROR: Cannot continue with install #Step 1#
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Cause |
Solution |
Updates to /opt/oracle/bda/install/state/config.json |
Updates to /opt/oracle/bda/install/state/cluster-network.json |
Copy Updated /opt/oracle/bda/install/state/config.json and /opt/oracle/bda/cluster-network.json Files to All Cluster Nodes |
References |