R12: ASM Get APP-FND-00804 or APP-FND-00730 When Mapping Secondary Ledger Chart of Accounts (Doc ID 1104001.1)

Last updated on SEPTEMBER 16, 2016

Applies to:

Oracle General Ledger - Version 12.0.6 and later
Information in this document applies to any platform.
Chart of Accounts (COA)
Accounting Setup Manager (ASM)

Symptoms

When attempting to map the chart of accounts from the Primary Ledger COA to a Secondary Ledger COA, the following error occurs.

ERROR
-----------------------
APP-FND-00804: Program Error. Invalid arguments to the flexfield routines. Please inform your support representative that:
Routine FDFGST unable to find flexfield qualifier 20. The flexfield routines have been called incorrectly.
Make sure the flexfield qualifiers specified match those defined in the Register Key Flexfield form.
or

APP-FND-00730: This flexfield has an invalid value set. It may use a special value set that uses an Edit event user exit, and the user exit has failed.
If you are using a form on a graphical user interface (GUI) you may have an invalid value set of a different type, possibly a table-validated value set where the table or view does not exist or where there is an invalid WHERE clause.
Contact your system administrator or support representative to check and correct the value sets this flexfield uses.

Other reports/forms might throw similar error messages.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Under Consolidation>Define, click on Mapping Set
2. Create mapping set for secondary ledger COA, and click on Segment Rules
3. Attempt to create source and target mapping rules, including a constant value. Error received every time
 

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms