R12: Requisition Import Program Does Not Populate Correct Quantity For Fixed Lot Multiplier Setup (Doc ID 1321417.1)

Last updated on JUNE 01, 2016

Applies to:

Oracle Purchasing - Version 12.1.2 and later
Information in this document applies to any platform.
REQIMPORT: Requisition Import Program
POXSRCDB.pls

Symptoms

While running Requisition Import Program,
The Quantity for this Requisition gets changed at runtime depending on what Minimum Order Quantity is set (Under Order Modifiers)
In the Approved Supplier List for a particular Item

Steps to reproduce:

1. In the Supplier Item Attributes Under Order Modifiers,
    Set Minimum Order Quantity = 300 and Fixed Lot Multiplier = 150

2. Replenishment Count Headers/lines show the foll for this item
    Count Type = Order Quantity and Quantity = 600

3. Run the below request, and check to see table PO_REQUISITIONS_INTERFACE_ALL, the quality is 600.
    i.e Process Replenishment Count and Item Replenishment Count

4. But when Requisition Import is run requisition Quantity = 300
    (i.e Quantity on REQ turns same as Minimum Order Quantity = 300)

However if you set Minimum Order Quantity = Null and Fixed Lot Multiplier = 150 then after Requisition Import is Run Requisition Quantity = 4
(i.e Quantity defined in Replenishment count Lines= 600/Fixed Lot Multiplier = 150 => 600/150 = 4)

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms