My Oracle Support Banner

Relay Order Movement Functionality Is Not Creating and Updating Order Movements Correctly. (Doc ID 1399985.1)

Last updated on SEPTEMBER 08, 2016

Applies to:

Oracle Transportation Management - Version: 6.2.4 to 6.2.5 - Release: 6.2 to 6.2
Information in this document applies to any platform.

Symptoms


On OTM version 6.2.4 when using Relay Order Movement the action does not create the Order Movements correctly.


ACTUAL BEHAVIOR
---------------
Two Order Movements are created but the locations for source and destination are not correct nor is the Ship Unit on the second Order Movement.

EXPECTED BEHAVIOR
-----------------------
If the original Order Movement is from A to B and the Relay Action is used to relay via location B, the result should be two Order Movements, A > B and B > C both for the same Ship Unit.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create an Order Movement from Location A to Location C
2. From the Order Movement click Actions > Order Management > Change Order > Create Relay Order Movement.
3. Enter relay location B.
4. Two Order Movements are created but the source and destination is incorrect on the first Order Movement and the second Order Movement does not contain the Ship Unit.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
  Symptoms
  Cause
  Solution
  References

This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.