After Merging Two Shipments, Load Pattern ID Is Not Getting Copied Onto The Merged Ship Unit (Doc ID 1502476.1)

Last updated on JULY 20, 2024

Applies to:

Symptoms

On OTM version 6.2

ACTUAL BEHAVIOR
---------------
When two shipments are merged for the Ship Units the Loading Pattern is lost.

EXPECTED BEHAVIOR
-----------------------
Expect the Loading Pattern to be kept.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

TEST CASE:

1 - Log on to OTM.

2 - Create two Orders with the same origin and destination.

3 - Plan both orders separately creating two Shipments

4 - Shipments created were:
0001
0002

5 - Edit both Shipments, go to Equipment Tab > Shipment equipment and note the Loading Pattern ID is LENGTHWISE

6 - Select both Shipments and click Actions > Operational Planning > change Shipment Route > Merge Shipments.

7 - Clicked OK.

8 - In the Merge Shipments screen select one of the Shipment IDs from the Shipment ID drop down.

9 - Click Manual.

10 - The merged Shipment is created/used.

11 - Edit the shipment and drill down to the Shipment Equipment

12 - The result was:
One Ship Unit had LENGTHWISE
One Ship Unit had no Loading Pattern ID

Cause

My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.