R12: Schedule Order concurrent not honouring "Schedule Line on Hold" system parameter (Doc ID 1589962.1)

Last updated on JULY 13, 2016

Applies to:

Oracle Order Management - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3 version, Scheduling and Sourcing

Actual
-----------
Concurrent program "SCHORD module: Schedule Orders" does not honour
System Parameter setting "ONT_SCHEDULE_LINE_ON_HOLD".

Expected
-----------
If "ONT_SCHEDULE_LINE_ON_HOLD" = Yes, then the "Schedule Orders" concurrent program should
progress and schedule identified lines even considering these lines might be on Hold.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Set System Parameter, ONT_SCHEDULE_LINE_ON_HOLD (Schedule Line on Hold) = Yes
1. Enter order, with a single line (AutoSchedule = N)
2. Book the order
3. Place the order/line on a Hold
4. Now run "Schedule Orders" (SCHORD) concurrent
5. Order does NOT schedule and returns

Message
-----------
Order Number :999999 Line Number :3.1
Message :Could not schedule. Line on hold.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms