OTM Not Looking At Conopt Logic Configuration Set When ConOpt Configuration is Not Used
(Doc ID 1605413.1)
Last updated on JULY 20, 2024
Applies to:
Oracle Transportation Operational Planning - Version 6.0 to 6.3.3 [Release 6 to 6.3]Information in this document applies to any platform.
Symptoms
When you set the CONTAINER OPT CONFIG ID to blank (using Default Value) it is expected that the values in the LOGIC CONFIG SET ID be used to display the 3D Load Configuration, instead when you View Load Config action, the following error is seen:
"The loading configuration of Shipment Equipment XX.XXXX cannot be shown in 3D."
Cause
To view full details, sign in with your My Oracle Support account. |
|
Don't have a My Oracle Support account? Click to get started! |
In this Document
Symptoms |
Cause |
Solution |
References |