Issue With Change Type During Mass Change (Doc ID 1904084.1)

Last updated on JULY 03, 2014

Applies to:

Oracle Bills of Material - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3 version, Bills/Routings Setup

ACTUAL BEHAVIOR
---------------
After defining a change type in the Setup>Change Types form with Used For defined as Engineering and Manufacturing, the change type is not available in the Mass Change Bills form.
However, if the Used for is changed to Manufacturing Only, then it is available in the Mass Change Bills form.

EXPECTED BEHAVIOR
-----------------------
Expect changes types that are defined as Used for Engineering and Manufacturing to be available in the Mass Change Bills form.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Define a change type with Used for as Engineering and Manufacturing in the Setup>Change Types form
2. Navigate to the Bill of Materials>Mass Change Bills form and try to use the change type
3. The change type is not available in the list of values.

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, users cannot use the newly created change type. This is holding up needed changes to bills of materials which opens up the possibility that items could be built incorrectly.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms