Run To Failure Flag Checked Stops Generation of PM Work Orders

(Doc ID 1985466.1)

Last updated on JUNE 23, 2017

Applies to:

Oracle Enterprise Asset Management - Version 12.1.3.1 and later
Information in this document applies to any platform.

Symptoms



ACTUAL BEHAVIOR

When running the Generate Preventive Maintenance Work Orders program, the request completes normally but does not generate work orders.


EXPECTED BEHAVIOR

Work orders should be generated by the Generate Preventive Maintenance Work Orders program.


STEPS

The issue can be reproduced at will with the following steps:
1. Responsibility: Enterprise Asset Management
2. Navigation: Preventive Maintenance -> Generate Preventive Maintenance Work Orders
3. Enter parameters as:
  Start Date = 02-06-2015
  Cut-Off Date = 03-06-2015
  Asset Type = Capital
  Asset Group = Bagging
  Asset Number = DLN2-PAC-BAGR100
4. Click Submit
5. Program completed normally but no work orders were generated.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms