My Oracle Support Banner

Entering Sales Order, Quote Or Sales Agreement Errors With Either APP-FND-01702 Or APP-FND-01728 (Doc ID 2031743.1)

Last updated on DECEMBER 10, 2024

Applies to:

Oracle Order Management - Version 12 and later
Information in this document applies to any platform.

Symptoms

Attempting to perform any of the actions below can error with the following:

  1. Enter a sales order.
  2. Enter a quote.
  3. Create a sales agreement with transaction type = XXX.
  4. Import new order with order import.

Error

NOTE !
Error raised is dependent on the value of the profile option Sequential Numbering:

If value is 'Partially Used':

APP-FND-01728: An assignment does not exist for these parameters.

Details of possible error messages if set to partially used:

Cause: An attempt was made to find a sequence for this document flexfield. The profile option says
Sequential Numbering is only partially used.
Action: None is necessary unless you expected this document flexfield to have a sequence defined
in Package OE_Header_Util Procedure Get_Order_Number


Cause: An attempt was made to find a sequence for this document flexfield
The profile options says Sequential Numbering is only partially used.
Action: None is necessary unless you expected this document flexfield to have a sequence defined
in Package OE_Header_Util Procedure Get_Order_Number


User Defined Exception in Package OE_Header_Util Procedure Pre_Write_Process


Cause: An attempt was made to find a sequence for this document flexfield.
The profile option says Sequential Numbering is only partially used.
 
Action: None is necessary unless you expected this document flexfield to have
a sequence defined. in Package OE_Blanket_Util Procedure Get_Order_Number


If value is 'Always Used':

APP-FND-01702: An assignment does not exist for these parameters and one is mandatory.

Details of error message if set to always used:

Cause: The profile option Sequential Numbering is defined to have sequential numbering always used.
The current set of parameters does not have a sequence assigned.

Action: Go to the Assign Sequences screen and assign a sequence to the current set of parameters. in Package
0E_Header_Util Procedure Get_0rder_Number

 

STEPS:

1) Order Management Super User Responsibility

2) Enter any of the following:

Changes

 

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Changes
Cause
Solution
References


My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.