RA_AUTOINV_TRX_NUMBER Value Set Test Error: You may not use GROUP BY in your WHERE clause (Doc ID 2069191.1)

Last updated on NOVEMBER 11, 2015

Applies to:

Oracle Receivables - Version 11.5.10.2 and later
Information in this document applies to any platform.

Symptoms

On : 11.5.10.2 version and higher, Setup Related Issues

When click on Test button of Value Set RA_AUTOINV_TRX_NUMBER, the following error occurred.

Test of value set RA_AUTOINV_TRX_NUMBER failed with following error message :
You may not use GROUP BY in your WHERE clause
select replace(TRX_NUMBER,'''','''''') VALUE from RA_INTERFACE_LINES where rowid in ( select min(rowid) from ra_interface_lines where trx_number is not null group by trx_number ) order by trx_number


The issue can be reproduced at will with the following steps:

  1. Open Value Sets window and query on RA_AUTOINV_TRX_NUMBER
  2. Open Validation Table Information window
  3. Click on Test button
  4. Error occur.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms