My Oracle Support Banner

Wip Mass Load Changes Required Quantity on a Discrete Job Back to Default After the Change Done On the Material Requirement. (Doc ID 2074302.1)

Last updated on MARCH 08, 2017

Applies to:

Oracle Work in Process - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms


ACTUAL BEHAVIOR

Users change required quantities on a Work Order's Bill of Materials. Looks at the job the next day and the "Required Quantities" has reverted back to the default required quantities.

EXPECTED BEHAVIOR

Required Quantity should remain the same  after the change was saved.

STEPS
-----------------------
The issue can be seen with the following steps:
1. Responsibility: Work in Process

2. Navigate to WIP - Job/Schedule Details - Material Requirements.

3. Change the Required Quantity on the Components.

4. Wait for a Day and See the Required Quantity is reverted back to the default values as in the Bills of Material Prior to the Change.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.
My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.