Mobile MSC Hit Ctrl L Brings all Lots Instead of only Specific Lot Numbers that are Active for the Item/Sub-inventory/Stock Locator Combination

(Doc ID 2077694.1)

Last updated on MAY 15, 2016

Applies to:

Oracle Inventory Management - Version 12.2.4 and later
Information in this document applies to any platform.

Symptoms

Find that when performing a Miscellaneous  Issue from mobile after entering Item, Subinventory and Locator that the Lot LOV shows all available Lots. It should only show the Lots that are in specified Subinventory/Locator combination for the item.

EXPECTED BEHAVIOR
-----------------------
Expect only lots from that Subinventory/Locator to be listed.

When user trying to Misc issue from mobile the system displaying all the locators with the sub inv locator combination.  It should only display the locators where on hand quantity exists for the item.


STEPS
-----------------------
The issue can be reproduced at will with the following steps:

Item: Item1
LOT BA001 Bulk Subinventory Locator B1.1.1 QTY 10
LOT BA002 CASE Subinventory Locatory C1.1.1 QTY 10

Performed MISC ISSUE from BULK. hi Ctrl L: Lot LOV showed both lots and I was able to select Lot BA002 even though it is not in subinventory BULK.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms