Asset Location Setup Should Not Allow End-Dated Locations (Doc ID 2079877.1)

Last updated on MARCH 08, 2017

Applies to:

Oracle Installed Base - Version 12.1.3 and later
Information in this document applies to any platform.

Symptoms

On : 12.1.3 version

Asset Location Mapping form should not allow end-dated locations to be selected for association.

EXPECTED BEHAVIOR
-----------------------
End-dated locations should not appear in Asset Location Mapping form.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:

Perform the standard steps to Associate HR and HZ Locations with Asset Locations

Assign HR and HZ locations to the Asset location using Asset Location Setup.

Prerequisites: Define HR and HZ locations.

To associate HR and HZ locations with asset locations:
  In the Oracle Install Base responsibility, choose Setups and then select Asset Location Setup.
  Select location source as HR.
  Choose an end-dated location code from the list of values.
  Assign Asset location.
  Enter active start date.
  You can disable the particular relationship by entering active end date.
  Save.

Due to this issue, users cannot distinguish between active and end_dated locations, hence creating wrong mappings.

Cause

Sign In with your My Oracle Support account

Don't have a My Oracle Support account? Click to get started

My Oracle Support provides customers with access to over a
Million Knowledge Articles and hundreds of Community platforms