My Oracle Support Banner

'Change Lot Status From' Field Is Not Getting Defaulted On Change Disposition Form After R12.2 Upgrade (Doc ID 2083781.1)

Last updated on MARCH 08, 2017

Applies to:

Oracle Process Manufacturing Product Development - Version 12.2.4 and later
Information in this document applies to any platform.

Symptoms

On : 12.2.4 version, Quality Management Samples

ACTUAL BEHAVIOR
---------------
Using Onhand Material Status

On the sample Change Disposition form, the Change Lot Status From field is showing a blank value, even though the lot exists in only one subinventory and locator.

This had been working correctly for the customer in 12.1. They upgraded to 12.2, and it apparently was still working correctly. They then applied <patch 20690630> which provided version GMDQCDIS.fmb 120.39.12020000.15, and after that the Change Lot Status From field stopped showing a value. Customer then applied <patch 20802158> to get version 120.39.12020000.18, but the field is still blank.

EXPECTED BEHAVIOR
-----------------------
Expect the Change Lot Status From field to show the current onhand status of the lot when the lot is in only one location.

STEPS
-----------------------
The issue can be reproduced at will with the following steps:
1. Create sample
2. Enter results
3. Go to Change Disposition

BUSINESS IMPACT
-----------------------
The issue has the following business impact:
Due to this issue, users cannot see the current status.

Cause

To view full details, sign in with your My Oracle Support account.

Don't have a My Oracle Support account? Click to get started!


In this Document
Symptoms
Cause
Solution
References


This document is being delivered to you via Oracle Support's Rapid Visibility (RaV) process and therefore has not been subject to an independent technical review.
My Oracle Support provides customers with access to over a million knowledge articles and a vibrant support community of peers and Oracle experts.